WHEN REFUELING VEHICLE, GAS PUMP AUTO-SHUT-OFF FAILS AND GASOLINE SPILLS OUT FILLER NECK ONTO REAR PANEL AND GROUND. DEPENDING ON HANDLE SETTING, SPILL IS EITHER BACKSPLASH OR JUST OVERFLOW, BUT ALWAYS SPILLS. *TR
2013
EQUIPMENT ADAPTIVE
WHILE TRAVELING DOWN A HIGHWAY AT 55, I ADJUSTED MY POSITION IN THE SEAT. THE VEHICLE WAS IN CRUISE CONTROL. I PLACED MY FEET ON THE CARPET IN FRONT OF THE SEAT AND PUSHED MYSELF UP AND BACK INTO THE SEAT TO ADJUST MY COMFORT AND POSITION. THE CARPET AND CARPET MAT WENT UP INTO THE BRAKE AND ACCELERATOR PEDALS. THE VEHICLE BEGAN TO ACCELERATE. WITH MY FEET I PULLED THE CARPET AND THE MAT BACK AND OUT OF THE PEDALS. STOPPED THE VEHICLE AND MOVED OFF TO THE SIDE OF THE HIGHWAY. I GOT OUT OF THE VEHICLE TO SEE THE CAUSE. THE DRIVER SIDE CARPET IS A SEPARATE PIECE OF CARPET WITH A MAT ATTACHED BY A HOOK THAT IS PART OF THE CARPET. THE CARPET DOES NOT SEEM TO HAVE ANY BACKING. IT LOOKS SPUN. THE DRIVER POSITION CARPET IS A SEPARATE PIECE THAT TERMINATES ABOUT 6 TO 10 INCHES UNDER THE DRIVERВїїS SEAT. THE CARPET HAS HOLES THAT ALLOW THE DRIVER SEAT FRAME TO ATTACH TO THE FLOOR OF THE VEHICLE WITHOUT CLAMPING THE CARPET DOWN. THERE IS NO CLAMPING FORCE HOLDING THE CARPET DOWN UNDER THE DRIVER SEAT. THE CARPET END UNDER THE SEAT IS PLACED UNDER THE CARPET COMING FROM THE BACK SEAT. I DID NOT NOTICE ANY ATTACHMENT BETWEEN THE FRONT AND BACK CARPET TO HOLD THE CARPET IN PLACE. MY ACTION OF PUSH WITH MY FEET TO ADJUST MY COMFORT AND POSITION RIPPED THE CARPET ON THE OUTSIDE EDGE BY THE DRIVER SIDE DOOR AND STRETCHED THE CARPET ON THE RIGHT SIDE, WHICH LET THE LEFT SIDE OF THE CARPET TO MOVE UP INTO THE BREAK AND ACCELERATOR PEDALS. I REPLACED CARPET MAT WITH THE HARD MOLDED RUBBER MATS. THESE MATS SEEM TO KEEP THE CARPET AND MATS FROM MOVING UP INTO THE PEDALS. THE MATS AND CARPET STILL SHIFT FORWARD AND I HAVE TO ADJUST THEM WHEN THE CARPET GETS TOO FAR FORWARD. *TR
