GVWR: Class 2G: 8,001 - 9,000 lb (3,629 - 4,082 kg)
Make: GMC
Manufacturer: GENERAL MOTORS LLC
Manufacturer Id: 984
Model: Savana
Model Year: 2006
Other Engine Info: MFI, Iron, 8Cyl
Plant City: Wentzville
Plant Company Name: GMNA
Plant Country: United States (USA)
Plant State: Missouri
Trim: 2500 (3/4 Ton)
Vehicle Type: TRUCK
Model year
COMPONENT
Complaint
2003
POWER TRAIN:AUTOMATIC TRANSMISSION
DT*: THE CONTACT STATED WHILE DRIVING 35 MPH THE TRANSMISSION FAILED. THE VEHICLE WAS TAKEN TO THE SERVICE DEALER WHERE PARTS IN THE TRANSMISSION WERE REPLACED. AFTER 90,000 MILES, THE TRANSMISSION CEASED TO OPERATE AGAIN. THE VEHICLE WAS TAKEN TO A DIFFERENT SERVICE DEALER WHO OFFERED TO REPLACE THE TRANSMISSION IF A WARRANTY PACKAGE WAS PURCHASED AND THE TRANSMISSION WAS REPLACED. DURING THIS VISIT TO THE 2ND DEALER, A DIAGNOSTIC TEST WAS PERFORMED WHERE THE TAIL LIGHT WAS DISCOVERED NOT TO BE WORKING. THERE WAS NO REPAIR WORK PERFORMED FOR THE TAIL LIGHT. THE CONTACT ALSO EXPRESSED THAT ONE DAY THE DRIVER SEAT BELT WOULD NOT UNLATCHED SO THE SEAT BELT WAS BROKEN TO RELEASE THE CONTACT. THE VEHICLE WAS TAKEN TO THE SERVICE DEALER FOR RECALL REMEDY #05113 PERTAINING TO THE SEAT BELT. WHILE AT THE DEALER THE REMEDY REPAIR WORK WAS PERFORMED ON THE PASSENGER SEAT BELT BUT NOT THE DRIVER'S SEAT BELT. AFTER THE REMEDY REPAIR TO THE PASSENGER SEAT BELT, IT NO LONGER WORKED PROPERLY. THE SERVICE DEALER WAS CONTACTED; HOWEVER THE SERVICE DEALER HAD TO ORDER THE PARTS FOR ADDITIONAL REPAIRS. ALSO, WHILE DRIVING 25 MPH THE LUG NUT ON THE HUB CAP DETACHED. THE VEHICLE WAS TAKEN TO THE SERVICE DEALER WHERE PLASTIC LUG NUTS WERE INSTALLED AND THEY DETACHED AGAIN. WHEN THE VEHICLE WAS TAKEN BACK TO THE DEALER, THE SERVICE MANAGER RECOMMENDED THE LUG NUTS BE GLUED ON. THE CONTACT TOOK THE VEHICLE TO A TIRE COMPANY WHO INSTALLED BRAND NEW TIRES AND LUG NUTS.
2006
STEERING
THE POWER STEERING HOSE WAS RUBBING AGAINST THE POWER STEERING PULLEY. THE RUBBING CAUSE THE HOSE TO FAIL AND LEAK POWER STEERING FLUID ON THE PULLEY, SERPENTINE BELT AND NEARBY COMPONENTS. I DID NOT SEE ANY CLAMPS TO HOLD THE HOSE AWAY FROM ANY MOVING PARTS. *TR
