Ownership Cost for 2008 Ford Crown Victoria (Police Interceptor)
Estimated: $39456 over the next 5 years
Year 1
Year 2
Year 3
Year 4
Year 5
Total
Depreciation
$1551
$745
$651
$589
$527
$4063
Insurance
$1567
$1622
$1679
$1737
$1798
$8403
Fuel
$2229
$2295
$2376
$2471
$2582
$11953
Maintenance
$2763
$1538
$847
$509
$2291
$7948
Repairs
$977
$1138
$1298
$1417
$1627
$6457
Taxes & Fees
$426
$426
$426
$426
$426
$631
Total Ownership Costs
$9513
$7387
$6912
$6763
$8881
$39456
Air Bag Loc Curtain: 1st Row (Driver & Passenger)
Air Bag Loc Front: 1st Row (Driver & Passenger)
Air Bag Loc Side: 1st Row (Driver & Passenger)
Body Class: Sedan/Saloon
Displacement CC: 4600.0
Displacement CI: 280.70922283576
Displacement L: 4.6
Doors: 4
Engine Configuration: V-Shaped
Engine Cylinders: 8
Engine HP: 224
Engine H P_to: 239
Engine KW: 167.0368
Fuel Type Primary: Flexible Fuel Vehicle (FFV)
Make: FORD
Manufacturer: FORD MOTOR COMPANY OF CANADA, LTD.
Manufacturer Id: 977
Model: Crown Victoria
Model Year: 2008
Plant City: Talbotville
Plant Company Name: St. Thomas
Plant Country: Canada
Plant State: Ontario
Seat Belts All: Manual
TPMS: Direct
Trim: Police Interceptor
Valve Train Design: Single Overhead Cam (SOHC)
Vehicle Type: PASSENGER CAR
Model year
COMPONENT
Complaint
1994
SERVICE BRAKES, HYDRAULIC:SWITCHES:BRAKE WARNING
BRAKE LIGHT CAME ON ON APPLIED BRAKES, DRIVER AND PASSENGER AIR BAGS DEPLOYED, RESULTING IN REAR END COLLISION. *AK
2008
ELECTRICAL SYSTEM:WIRING
2008 FORD CROWN VICTORIA HAS A PROBLEM WITH UNINTENDED ACCELERATION. *NJ THE CONSUMER STATED THE VEHICLE ACCELERATED 3 TIMES WITH NO WARNING. THE CONSUMER STATED THE PROBLEM HAPPENED WHEN THE VEHICLE WAS STARTED AND PLACED INTO DRIVE AND DRIVEN APPROXIMATELY 150 FEET. THE RPM'S INCREASED WITHOUT THE ACCELERATOR BEING APPLIED. THE CONSUMER APPLIED THE BRAKE AND THE RPM'S RETURNED TO NORMAL AFTER ABOUT 30 SECONDS. THE CRUISE CONTROL WAS NOT ENGAGED. IN JUNE 2009, THE CONSUMER TOOK THE VEHICLE TO THE DEALER AND THEY REPLACED THE THROTTLE BODY AND AIR INTAKE. HOWEVER, ON AUGUST 13, 2009 THE VEHICLE ACCELERATED SUDDENLY AS IT DID PREVIOUSLY. THE CONSUMER TOOK THE VEHICLE BACK TO THE DEALER AND THEY FOUND 2 PIN HOLES IN THE BASIC WIRING HARNESS. THE CONSUMER WAS INFORMED THE PIN HOLES WERE A RESULT OF THE WIRING HARNESS BEING INSTALLED UPSIDE DOWN WHICH CAUSED TENSION AND RUBBING ON THE WIRE INSULATION UNTIL THE BARE WIRES WERE EXPOSED WHICH CAUSED A SHORT IN THE WIRING HARNESS. THE DEALER REPAIRED THE WIRES, BUT DID NOT REPLACE ANY PARTS. TO DATE NO FURTHER PROBLEMS HAVE OCCURRED. *JB